3D Models Available

April 6, 2017/in Engineering Tips/by JFW Eng Dept

3D Models in STEP or IGES Format

Our Drafting Department has created a library of 3D models for almost every JFW model listed on our website. If you would like a 3D model, please email our Drafting Department the 3D model format you prefer (STEP, IGES) and the JFW model number.

Recent Posts

What is the use of a fixed attenuator?April 15, 2024 - 11:36 am
A fixed attenuator has two main uses: decrease signal power level, improve poor VSWR. A fixed attenuator is a passive device with internal resistors whose resistive values are calculated base on the impedance (50 Ohm or 75 Ohm) and the desired attenuation value. The attenuation value is expressed in terms of decibel (dB). When the […]
What is the difference between reactive and resistive power dividers?April 12, 2024 - 2:42 pm
Understanding the difference between reactive and resistive power dividers will help you create the best functionality for your RF testing setup. Their functionality is similar but yet different. Resistive Power Dividers Their construction is a star configuration. All ports are symmetrical. There is no common port with resistive type design. The star configurations functions as […]
What are the 3 types of electro-mechanical RF switches?April 11, 2024 - 11:38 am
The goal of this application note is to differentiate the three different types of electro-mechanical RF switch types. Each type has its own unique functionality and its own pros and cons. Understanding their differences is key to getting the functionality you require. There is a cost tradeoff for latching and failsafe/normally open functionality. Mechanically latching […]

3D Models Available

Product Search

Resources

Products

Contact